Lower Facial Third
The share of the full face height between the base of the nose and the bottom of the chin.
- Formula
- Height from nose base to chin ÷ full face height × 100
- Unit
- Percent (%)
- Photo
- Front view
How it is measured
- Front view: mark the nose base on the midline (subnasale) and the lowest point of the chin.
- Measure the vertical height between them.
- Divide it by the hairline-to-chin height and multiply by 100.
Reading the value
- Lower
- Nose base and chin lie close together within the face.
- Higher
- Nose base and chin lie far apart within the face.
Why it matters
Lips, teeth and chin share this third. Its height sets the balance between upper and lower face, while the lip and chin ratios show how the space is divided. In millimetres this third is taller in men on average, with wide overlap; it also changes with tooth contact and jaw position.
Limits
From the front the chin bottom is a shading gradient that light can move by up to about 3 mm, and a beard hides it. An open mouth lengthens this third. The full height starts at the hairline, so light hair can shift the value and a fringe or shaved head leaves it empty.
Use a level, directly front-facing photo with even light. Head rotation, expression, hair or shadows can hide or shift the points. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.
Video guide
Research
- Clear aligners for correcting a receding lower jaw in growing patientsOrthod Craniofac Res · 2025 · meta-analysis · Strong evidence
Aligners were associated with reduced convexity, overjet and jaw discrepancy and increased lower jaw length and lower face height; 13 studies found no meaningful difference from other functional appliances.
- Typical lip and lower-face measurements in adults of European descentAesthetic Plast Surg · 2024 · meta-analysis · Strong evidence
Pooled values were produced for lip width, nose width, face width, lower face height, upper and lower red-lip height, upper lip skin height, and the nasolabial and mentolabial angles. The authors found that attractiveness in this region was tied to balanced proportions and that measurement methods were not standardised.
- How facial proportions differ between ethnic groupsPlast Reconstr Surg · 2011 · systematic review · Strong evidence
Forehead height showed the largest differences between groups, and distance between the eyes and nose width also varied notably. No significant sex difference was found in the classical proportions.
- A computer program that measures the face from photos for jaw-surgery planningJ Clin Exp Dent · 2024 · validation study · Moderate evidence
The program measured face thirds, eye-corner distance, nose base, lip heights and lip gap; only middle-third height and lower red-lip height differed significantly from the real values.
- Facial proportions of young Black South African womenPlast Reconstr Surg Glob Open · 2023 · cross-sectional study · Moderate evidence
The upper third of the face tended to be smaller than the middle and lower thirds. Nose width exceeded the classical rule of one fifth of face width and was larger than in other groups, tip projection was greater than in Congolese and African American samples, and upper and lower lip heights were close to 1:1 with the lips ahead of the E-line.
- How the face changes with age in Korean women: 3D scansAnn Dermatol · 2021 · cross-sectional study · Moderate evidence
Compared with the youngest group, the oldest group had a narrower eye opening, a longer upper eyelid area, a wider nose, a longer lower face, a longer and wider philtrum, a thinner lower red lip and a wider mouth. Nasofrontal, nasomental and mentolabial angles were larger and the nasofacial angle smaller.
14 studies in the research library are linked to this measure; the strongest are shown. These studies describe the feature or how it is measured. They do not show that one value is better than another.
Procedures that change it
- Genioplasty+0.3 % in the simulated example on the reference face
- BSSO+0.2 % in the simulated example on the reference face
Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.
Measure your lower facial third – freeMeasured in your browser. Your scans are saved on your device.