Nasal Base-to-Bridge Width Ratio
How much wider the nose is at its wings than along its bridge, seen from the front.
- Formula
- Nose width at the nostril wings ÷ width of the nose bridge
- Unit
- Ratio (×)
- Photo
- Front view
How it is measured
- Front view: measure the nose width between the outer edges of the nostril wings.
- At a fixed bridge level, place each bridge edge halfway between the top of the ridge and the nose–cheek groove.
- Divide the wing width by this bridge width.
Reading the value
- Lower
- The bridge is broad compared with the base of the nose.
- Higher
- The bridge is slender compared with the base of the nose.
Why it matters
The value captures the change in width between the narrow upper nose and its wider base, something one width alone cannot show. A front photo shows no sharp bridge outline, so the bridge edge is a fixed convention rather than a measured edge, and the number is best read as an approximation.
Limits
Light along the nose changes how the bridge looks but not where its edges are placed, so shading is not captured. Smiling flares the wings, and an unclear wing crease falls back to an estimate. A turned head narrows one side of the nose.
Use a level, directly front-facing photo with even light. Head rotation, expression, hair or shadows can hide or shift the points. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.
Video guide
Research
- Putting the removed nasal hump back to smooth the bridgeAesthetic Plast Surg · 2011 · case series · Limited evidence
With a graft of adequate size, the nasal bridge ended up smooth in nearly all cases. When the graft was too small, its edges could show and the lower nose could look out of balance with the nasal root.
- How changing one part of the nose affects the restPlast Reconstr Surg · 1991 · case series · Limited evidence
Lowering the area between the eyes made the eyes look further apart and the nose longer; lowering the bridge widened the front view and turned the tip up. Narrowing the nostril base or trimming the nasal spine could reduce tip projection, and reducing projection could widen the nostril base.
These studies describe the feature or how it is measured. They do not show that one value is better than another.
Procedures that change it
- Rhinoplasty-0.17 in the simulated example on the reference face
- SARPE+0.05 in the simulated example on the reference face
Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.
Measure your nasal base-to-bridge width ratio – freeMeasured in your browser. Your scans are saved on your device.