Columella Base Height Relative to Alar Bases
How far the base of the central column (columella) between the nostrils, where it meets the upper lip, sits above or below the nostril-wing bases.
- Formula
- Height of the point where the nose meets the upper lip, compared with the bases of the nostril wings
- Unit
- Millimetres (mm)
- Photo
- Front view
How it is measured
- Front view: find the columella base on the midline, at the fold where nose and upper lip meet.
- Find both nostril-wing bases where each wing meets the lip, and average their heights.
- Take the vertical difference in millimetres, scaled from the iris; positive means the columella base sits lower.
Reading the value
- Lower
- Negative values: the columella base sits above the level of the wing bases.
- Higher
- Positive values: the columella base hangs below the level of the wing bases.
Why it matters
From the front, the step between the central column of the nose and its wings shapes the lower outline of the nose and where the upper lip begins. The value describes that step. It does not locate the nasal tip itself; that needs the side view.
Limits
The value is about as small as its points’ uncertainty, roughly half a millimetre, and millimetres assume an average iris size. Nodding shifts it by up to 0.1 mm per degree. Overhead light can hide the fold, and then an estimate is used.
Use a level, directly front-facing photo with even light. Head rotation, expression, hair or shadows can hide or shift the points. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.
Video guide
Research
- Normal size of the visible iris (corneal diameter)Cornea · 2005 · cross-sectional study · Moderate evidence
Average diameter was 11.71 mm (±0.42); 11.77 mm in men and 11.64 mm in women, a non-significant difference. Normal ranges were about 11.0–12.5 mm for men and 10.7–12.6 mm for women, with no right–left difference and a slight decrease with age.
These studies describe the feature or how it is measured. They do not show that one value is better than another.
Procedures that change it
- LeFort I-0.1 mm in the simulated example on the reference face
Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.
Measure your columella base height relative to alar bases – freeMeasured in your browser. Your scans are saved on your device.