CEPHRA

Ramus-to-Mandible Length Ratio

Length of the rear upright part of the jaw outline compared with the length of its lower border, both built from side-view lines.

Drawn on a sketched reference face. Solid: measured lines · dashed: helper lines.
Formula
Height of the back of the jaw ÷ length of the lower jaw edge
Unit
Ratio (×)
Photo
Side view

How it is measured

  1. Side view: draw a line from the tragus (the small flap in front of the ear canal) through the upper jaw-edge support.
  2. Draw the lower-border line through a jaw-border support and the lowest chin point; note where both lines cross.
  3. Extend the lower-border line forward to the photo vertical through the most forward chin point.
  4. Divide the tragus-to-crossing length by the crossing-to-chin-vertical length.

Reading the value

Lower
The upright rear segment is short relative to the lower border segment.
Higher
The upright rear segment is long relative to the lower border segment.

Why it matters

It compares the ramus (the rear upright part of the lower jaw) with the jaw body (its lower horizontal part), two segments that grow partly independently. The upright segment starts at an ear point, not on the jaw, and the remaining ends are constructed line crossings, so it describes an outline proportion rather than bone lengths.

Limits

The crossing of both lines and the forward end of the lower segment are computed; that end sits on a photo vertical, so head pitch changes the ratio. Jaw supports come from skin and shadow, so lighting or a beard shifts them; hair over the ear moves the tragus.

Use a level side photo with relaxed lips and a visible forehead, ear, chin and neck. Head tilt, hair, shadows or an incomplete outline can shift the lines. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.

Video guide

Reference example · the values and scores shown belong to the example face.

Research

  • Bone patterns behind a long face in children and adultsAm J Orthod · 1984 · cross-sectional study · Moderate evidence

    In both children and adults with long faces, anterior face height, mandibular plane angle and gonial angle were larger than normal; long-faced adults tended to have shorter rami (vertical jaw branches).

These studies describe the feature or how it is measured. They do not show that one value is better than another.

Procedures that change it

  • Trimax-0.051 in the simulated example on the reference face
  • Bimax-0.035 in the simulated example on the reference face
  • BSSO-0.033 in the simulated example on the reference face
  • Genioplasty-0.031 in the simulated example on the reference face
  • Chin implants-0.022 in the simulated example on the reference face
  • Jaw implants+0.014 in the simulated example on the reference face

Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.

Measure your ramus-to-mandible length ratio – freeMeasured in your browser. Your scans are saved on your device.