CEPHRA

Interior Midface Projection Angle

Steepness of a line from the nostril-wing crease up to the outer eye corner, measured against the photo horizontal.

Drawn on a sketched reference face. Solid: measured lines · dashed: helper lines · arc: the angle.
Formula
Angle of the line from the outer eye corner to the nostril wing against the horizontal
Unit
Degrees (°)
Photo
Side view

How it is measured

  1. Side view: mark the rear end of the crease between nostril wing and cheek.
  2. Mark the outer eye corner (lateral canthus) as seen in profile.
  3. Measure the angle of the line joining them against the photo horizontal at the crease point.

Reading the value

Lower
A flatter line: the eye corner lies further back relative to its height above the crease.
Higher
A steeper line: the eye corner lies more directly above the crease.

Why it matters

It describes how far the nostril-wing crease sits forward of the outer eye corner relative to their height difference. It is a construction from two surface points, not a measure of cheekbone or upper-jaw projection.

Limits

The photo horizontal is the reference, so head pitch changes the value directly. Shadow in the crease and an eye corner hidden by lashes or a squint move the points; if the corner’s edge stays unclear, a labelled estimate is used instead.

Use a level side photo with relaxed lips and a visible forehead, ear, chin and neck. Head tilt, hair, shadows or an incomplete outline can shift the lines. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.

Video guide

Reference example · the values and scores shown belong to the example face.

Research

  • Building up a sunken front upper jaw around the nose baseSemin Plast Surg · 2020 · narrative review · Limited evidence

    The authors note that a set-back premaxilla can go with a sharp nasolabial angle and a drooping nasal tip, and that small deficits can be treated with implants, the patient's own tissue, fat transfer or filler; no outcome numbers are given.

  • How the facial bones shrink with ageAesthetic Plast Surg · 2012 · narrative review · Limited evidence

    Areas with a strong tendency to resorb are the midface (maxilla and the bone beside the nose), the upper-inner and lower-outer orbital rim, and the prejowl part of the lower jaw (mandible).

These studies describe the feature or how it is measured. They do not show that one value is better than another.

Procedures that change it

  • LeFort I-2.7° in the simulated example on the reference face
  • Bimax-2.3° in the simulated example on the reference face
  • Trimax-2.3° in the simulated example on the reference face
  • Cheek filler-0.5° in the simulated example on the reference face

Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.

Measure your interior midface projection angle – freeMeasured in your browser. Your scans are saved on your device.