CEPHRA

Middle Facial Third

The share of the full face height lying between the brows and the base of the nose.

Drawn on a sketched reference face. Solid: measured lines · dashed: helper lines.
Formula
Height from brows to nose base ÷ full face height × 100
Unit
Percent (%)
Photo
Front view

How it is measured

  1. Front view: mark the brow level as the midpoint of the four inner brow-end points.
  2. Mark the nose base on the midline (subnasale).
  3. Divide the brow-to-nose-base height by the hairline-to-chin height and multiply by 100.

Reading the value

Lower
The band from brows to nose base is short within the face.
Higher
The band from brows to nose base is tall within the face.

Why it matters

This third holds the eyes and most of the nose and links the forehead to the mouth region. Read with the other two thirds, it shows whether height is spread evenly or concentrated in one part of the face.

Limits

Its own two ends are well defined, but the full height contains the hairline, so hair colour affects it and a fringe or shaved head leaves it empty. Raised brows lengthen this third.

Use a level, directly front-facing photo with even light. Head rotation, expression, hair or shadows can hide or shift the points. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.

Video guide

Reference example · the values and scores shown belong to the example face.

Research

  • How facial proportions differ between ethnic groupsPlast Reconstr Surg · 2011 · systematic review · Strong evidence

    Forehead height showed the largest differences between groups, and distance between the eyes and nose width also varied notably. No significant sex difference was found in the classical proportions.

  • A computer program that measures the face from photos for jaw-surgery planningJ Clin Exp Dent · 2024 · validation study · Moderate evidence

    The program measured face thirds, eye-corner distance, nose base, lip heights and lip gap; only middle-third height and lower red-lip height differed significantly from the real values.

  • Facial proportions of young Black South African womenPlast Reconstr Surg Glob Open · 2023 · cross-sectional study · Moderate evidence

    The upper third of the face tended to be smaller than the middle and lower thirds. Nose width exceeded the classical rule of one fifth of face width and was larger than in other groups, tip projection was greater than in Congolese and African American samples, and upper and lower lip heights were close to 1:1 with the lips ahead of the E-line.

  • Classical face proportion rules rarely fit Asian or White facesAesthetic Plast Surg · 2002 · cross-sectional study · Moderate evidence

    In no group were the three vertical sections of the face equal. Other canons held in 17-37% of White and 2-27% of Asian participants; Asian faces had a wider distance between the eyes relative to eye length, a wider nose, a narrower mouth and a lower face shorter than the forehead.

  • Do classic 'ideal' face proportion rules fit real faces?Plast Reconstr Surg · 1985 · cross-sectional study · Moderate evidence

    The rules that fitted most often were horizontal ones: the gap between the eyes equalled nose width in 40%, and nose width equalled a quarter of face width in 37%. Vertical profile rules, such as equal facial thirds, fitted worst; sex made little difference, but age did.

  • Facial height proportions measured on X-rays in denture wearersGerodontology · 2005 · case series · Limited evidence

    The bony middle-to-lower face height ratio was about 0.8 ± 0.2, and the soft-tissue ratio (brow to nose base vs nose base to chin) stayed near 1; measures with dentures were similar.

These studies describe the feature or how it is measured. They do not show that one value is better than another.

Procedures that change it

  • Brow lift+0.6 % in the simulated example on the reference face
  • Forehead Botox-0.5 % in the simulated example on the reference face
  • LeFort I-0.1 % in the simulated example on the reference face

Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.

Measure your middle facial third – freeMeasured in your browser. Your scans are saved on your device.