Profile Nasal Width-to-Height Ratio
How far the nose reaches horizontally in the side view, compared with the vertical drop from the front of the eye to the tip.
- Formula
- Depth of the nose seen from the side ÷ height from the eye to the nose tip
- Unit
- Ratio (×)
- Photo
- Side view
How it is measured
- Side view: mark the nose tip and the rear end of the crease between nostril wing and cheek.
- Take their horizontal distance in the photo as the nose reach.
- Divide the nose reach by the vertical drop from the front of the eye (corneal apex estimate) down to tip height.
Reading the value
- Lower
- Less forward nose reach for a given drop from eye level to the tip.
- Higher
- More forward nose reach for a given drop from eye level to the tip.
Why it matters
Despite the word width, both parts come from the side view; it is not the front-view nostril width. It relates forward nasal reach to how far below eye level the tip sits, complementing the projection ratio, which uses a different length.
Limits
The photo horizontal and vertical are used directly, so tilting the head changes the ratio. The eye-front and crease points are photographic estimates, and a head turned towards the camera shortens the reach.
Use a level side photo with relaxed lips and a visible forehead, ear, chin and neck. Head tilt, hair, shadows or an incomplete outline can shift the lines. A measurement describes a photo, not a diagnosis, and no single value is good or bad on its own.
Video guide
Research
- Nose shape changes after two-jaw surgery, measured on 3D photosJ Formos Med Assoc · 2015 · cohort study · Moderate evidence
Alar base width stayed about the same and alar width rose by only 0.74 mm; nose height and length did not change. Tip projection fell by 1.99 mm while the nasolabial angle and visible nostril area increased; 37% felt their nose looked better, 58% saw no change and 5% were unhappy.
- Comparing ways to measure how far the nose tip projectsLaryngoscope · 1988 · validation study · Moderate evidence
Methods varied widely in how well they matched expert opinion. Relating tip projection to total nasal length including the upper lip matched best (r = 0.81); tip projection did not track upper-lip length well, and a slightly modified Goode method also proved useful.
- A stitch to keep the nose tip from drooping after rhinoplastyAesthetic Plast Surg · 2014 · case series · Limited evidence
Both the nasolabial angle and tip projection were significantly higher after surgery and did not change between 3 weeks and 1 year.
These studies describe the feature or how it is measured. They do not show that one value is better than another.
Procedures that change it
- LeFort I+0.02 in the simulated example on the reference face
- Rhinoplasty+0.01 in the simulated example on the reference face
- Cheek filler-0.01 in the simulated example on the reference face
- Non-surgical rhinoplasty+0.01 in the simulated example on the reference face
- Nose tip Botox-0.01 in the simulated example on the reference face
Each example uses the app’s starting strength on one reference face; on another face the same procedure moves this value by another amount.
Measure your profile nasal width-to-height ratio – freeMeasured in your browser. Your scans are saved on your device.