What are facial thirds?
Facial thirds divide the face from the hairline to the chin into three heights: forehead (hairline to brows), midface (brows to the base of the nose) and lower face (nose base to chin). Classical art drew them as equal; measured faces show that they rarely are, and the lower third is often split again into lip and chin.
How the thirds are measured
On a straight front photo, horizontal lines are drawn through the hairline, the brows, the base of the nose and the bottom of the chin. Each third is expressed as its share of the whole height, so the result does not depend on the size of the photo. The hairline is the least certain point: it moves with age and hairstyle, so the upper third is the most variable.
Within the lower third, the height from the nose base to where the lips meet is compared with the full lower-face height. An old proportion rule puts the lip line at about one third of it, so that the part below the lips is about twice the part above; measured faces vary around that mark.
Reading the thirds
A longer lower third makes a face read longer and is one of the features raters liked least in profile studies; a shorter one can make the chin look small. A long midface often goes with a longer nose or more space between the eyes and the mouth. Each value is compared with its typical range rather than with an exact third.
The measurements behind it
- Upper Facial ThirdThe share of the full face height taken up by the forehead, from the hairline down to the brows.
- Middle Facial ThirdThe share of the full face height lying between the brows and the base of the nose.
- Lower Facial ThirdThe share of the full face height between the base of the nose and the bottom of the chin.
- Upper Segment of Lower ThirdThe share of the lower face that lies above the lip line, from the nose base down to where the lips meet.
- Chin-to-Philtrum RatioChin height, from the lower lip border down, divided by the height of the philtrum, the groove above the upper lip.
- Lip Height to Lower Face HeightVisible height of upper and lower lip together, in percent of the vertical distance from the nasal base to the chin bottom.
Procedures that change these measurements
- Forehead lengthening / hairline raiseRaises the hairline so the forehead appears taller.
- GenioplastyMoves the chin forward and slightly down and widens it a little; the fold below the lower lip deepens as the chin comes forward.
- Chin implantsBrings the chin forward and widens it slightly.
- Lip liftRemoves a strip of skin under the nose so the upper lip gets shorter and more of the red lip shows; no volume is added.
General information, not medical advice. A surgeon or doctor explains what is suitable for you and its risks.
Research
- Typical lip and lower-face measurements in adults of European descentAesthetic Plast Surg · 2024 · meta-analysis · Strong evidence
Pooled values were produced for lip width, nose width, face width, lower face height, upper and lower red-lip height, upper lip skin height, and the nasolabial and mentolabial angles. The authors found that attractiveness in this region was tied to balanced proportions and that measurement methods were not standardised.
- Which side-profile shapes young adults preferredAm J Orthod · 1984 · cross-sectional study · Moderate evidence
Balanced (Class I normal) profiles were ranked highest and long, open profiles lowest. A convex nose bridge lowered ratings only in profiles with a set-back lower jaw. Rater sex and orthodontic training did not change preferences, but about 1 in 4 raters ranked differently on retest.
- Is the golden ratio really found in attractive faces?J Prosthet Dent · 2024 · systematic review · Strong evidence
A one-sample test showed no significant difference between measured ratios and the golden proportion, but the authors also reported no significant association between the golden ratio and facial attractiveness scores across ethnic groups, and facial height proportions did not follow the ratio.
Studies describe groups of people and how raters judged them; they do not say how any one person looks or should look. Checked 28 October 2026.
Questions
Should the three facial thirds be equal?
Equal thirds are an artist’s rule of thumb. Measured faces rarely have them; each third is better compared with the range that is common in a reference group.
Why is the upper third the least reliable?
It ends at the hairline, which differs with age, hair loss and hairstyle. The middle and lower thirds rest on bony landmarks and change less.
Can the facial thirds be changed?
The upper third changes with the hairline (for example a hairline lowering or a hair transplant); the lower third with chin procedures or a lip lift. A simulation shows how the measured thirds would move.
Measure your face – freeFree account, no card. Measured in your browser; your photos stay on your device.